PrintAirPipe - 125 AirFlowSensor segment - 3D printable - STL files

6,99 

Categories: , ,

Description

The PrintAirPipe - 125 AirFlowSensor Segment can be used to measure the volume of air moved or the speed of the air in the pipe system.

The electronics are based on an ESP32 S3, three LEDs and a Hall sensor. The entire electronics can be supplied with power via a USB-C cable. The rotational speed of the propeller inside is shown in an animation on the outside. (Further information in the video linked below)

Are you looking for other offers for the PrintAirPipe system? There are also the following segments:


Please note: No physical components will be sent. You will receive the files in STL format and must print them out on a 3D printer in order to build the project.

This offer contains the STL files you need to print the 3D printable components for the PrintAirPipe - 125 AirFlowSensor segment required.

  • You will soon find further information on the assembly and other components required in the assembly article. It will be linked here as soon as it is published.
  • Observe the safety instructions linked below during assembly and use: Click here

Additional components are required to build the complete project. A complete list of the required parts can be found here

Required tool:

Number Link
1x Screwdriver set  Buy at Amazon
1x Soldering iron  Buy at Amazon

Required material:

Number Link
1x SeeedStudio XIAO ESP32-S3  Buy at Amazon
2x Deep groove ball bearing 623ZZ  Buy at Amazon
3x WS2812 LED on PCB  Buy at Amazon
3x Hall sensor Melexis US1881   Buy at Amazon
3x Resistor 15k  Buy at Amazon
3x 5x5mm cylinder magnet  Buy at Amazon
3x M2x8 countersunk screw  Buy at Amazon
3x M2x10 countersunk head screw  Buy at Amazon
2x M3x6 countersunk head screw  Buy at Amazon
1x M3x30 countersunk screw  Buy at Amazon
6x M2 thread insert  Buy at Amazon
3x M3 thread insert  Buy at Amazon
1x Stranded wire  Buy at Amazon
1x  USB-C cable 5V/3A  Buy at Amazon
1x  USB power supply 5V/3A  Buy at Amazon
1x 3D printing FIlament PETG  Buy at Amazon

Gallery


3D printing information

The recommended 3D print settings are listed below. 

  • Filament type: e.g: PLA
  • Layer thickness: 0.2mm
  • Infill: 15%
  • Wall lines: 2

ESPHome example configuration

You can find an example configuration for ESPHome under the following link:


Videos


Dimensions

Below you can see an overview of the dimensions of the segment. If dimensions are missing, please use the contact form let us know and we will add this later.

 


File list

  • mcu_clamp_X.stl
  • PrintAirPipe_125mm_AirFlowSensor_electronics_housing_assembly_X.step
  • PrintAirPipe_125mm_AirFlowSensor_segment_electronics_lid_X.stl
  • PrintAirPipe_125mm_AirFlowSensor_segment_propeller_X.stl
  • PrintAirPipe_125mm_AirFlowSensor_segment_screw_plug_X.stl
  • PrintAirPipe_125mm_AirFlowSensor_segment_X.stl

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.