HowTo: PCB – Assemble the Anemosens sensor PCB

The Anemosens sensor PCB is the basis for the sensor assembly of Anemosens, a 3D printed anemometer that I developed for the second version of WinDIY.

For this purpose, an AH49E Hall sensor and an AS5048B I2C 14 bit magnetic rotary encoder are installed on the PCB. The AS5048B is used to determine the wind direction. With the help of the AH49E Hall sensor you can measure the wind speed by measuring the time of one complete revolution of the wind blades.

To finish the assembly of the PCB you need to divide it into two parts and solder it together at a 90° angle. The finished PCB can then mounted into the 3D printed housing from Anemosens and fixed with three M2x6 screws.

I had the circuit board manufactured by the circuit board manufacturer PCBWay.com , who made it available to me free of charge. At this point, thank you again for the great service and cooperation. 🙂

In the following you can see a few pictures of the finished circuit board and all possible components.

You can also see more information in the following video.

This video also shows the construction of the anemosens sensor PCB.

Safety instructions

I know the following hints are always a bit annoying and seem unnecessary. But unfortunately, many people who knew it "better" from carelessness lost their eyes, fingers or other things or hurt themselves. In comparison, a loss of data is almost not worth mentioning, but even these can be really annoying. Therefore, please take five minutes to read the safety instructions. Even the coolest project is worth no injury or other annoyance. https://www.nerdiy.de/en/sicherheitshinweise/

Affiliate links / advertising links

The links to online shops listed here are so-called affiliate links. If you click on such an affiliate link and shop via this link, Nerdiy.de receives a commission from the online shop or provider concerned. The price doesn't change for you. If you do your purchases via these links, you will support Nerdiy.de in being able to offer further useful projects in the future. 🙂


Requirements

For the construction you have to master SMD soldering tasks. The following articles provide tips on how to do this.

Benötigtes Werkzeug:

PCB manufacturing: You can find all the information you need to manufacture PCBs here:


The Assembly

In previous projects I inserted individual pictures at this point showing which components have to be soldered where on the PCB.

An even better way to get an overview of which components belong where on the PCB can be seen in the following paragraph. Thanks to the work of the Open Scope Project, you can now generate very helpful HTML files in which you can see directly which components have to be installed where on the PCB.

You can see the overview for the Anemosens Sensor-PCB here: Anemosens Sensor-PCB

The current file can also be found in the GIT repository under the following link:
https://github.com/Nerdiyde/Anemosens/blob/main/PCB/anemosens_sensor_pcb_v1.1_bom.html
(Please note that you have to download the HTML file in order to display it. This is not possible directly from the GIT repository.)


Programming firmware

The firmware for controlling the sensors on the Anemosens sensor PCB in combination with the Anemosens_MCU PCB is still under development. You can download the current status from the GIT-Repository . You can find the firmware under the following link.


I hope everything worked as described. If not or you have any other questions or suggestions, please let me know in the comments. Also, ideas for new projects are always welcome. 🙂

Fab

P.S. Many of these projects - especially the hardware projects - cost a lot of time and money. Of course I do this because I enjoy it, but if you appreciate it that I share these information with you, I would be happy about a small donation to the coffee box. 🙂

Buy Me a Coffee at ko-fi.com

Leave a Reply

Your email address will not be published. Required fields are marked *